2006 – 2007 Toyota vehicles SHOCK ABSORBER REPLACEMENT CRITERIA
download CONDITION Slight oil seepage from oil seal case Moderate oil seepage from oil seal case ACTION Normal oil evaporation — NOT necessary to replace the shock absorber Normal oil evaporation — NOT...
View Article2007 Chevrolet Silverado Early Oil Change Message Or Erratic Oil Life Monitor
download This PI was superseded to advise dealers there is no repair for early oil change messages or erratic OlM operation. Please discard PIP4540B. The following diagnosis might be helpful if the...
View Article1996 Isuzu Truck Rodeo Timing Belt Service and Repair
download REMOVAL STEPS Preparation: Battery ground cable 1. Radiator upper fan shroud ? Remove from radiator. 2. Cooling fan assembly ? Remove four nuts, then the cooling fan assembly. 3. Power...
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article2001 Isuzu Rodeo LS Timing Belt Removal
download Removal 1. Disconnect battery ground cable. 2. Remove air cleaner assembly. 3. Remove radiator upper fan shroud from radiator.4. 5. 6. 7. Move drive belt tensioner to loose side using wrench...
View Article2004 Honda Element EX ROCKER ARM OIL PRESSURE SWITCH (VTEC OIL PRESSURE SWITCH)
download 1. Check the engine oil level. Is the level OK? YES- Go to step 2 . NO- Adjust the engine oil to the proper level, then go to step 14 . 2. Turn the ignition switch ON (II). 3. Clear the DTC...
View Article2003 Saturn ION Engine Oil and Oil Filter Replacement Removal Procedure
download 1. Raise and support the vehicle. 2. Place a drain pan under the oil drain plug. 3. Remove the oil pan drain plug. Important: DO NOT use an open end wrench on the hex on top of the oil filter...
View Article1998 Isuzu Rodeo LS Timing Belt: Service and Repair REMOVAL
download 1. Disconnect battery ground cable. 2. Remove air cleaner assembly. 3. Remove radiator upper fan shroud from radiator. 4. 5. 6. 7. 8. 9. 10. 11. 12. Move drive belt tensioner to loose side...
View ArticleOil Filter Cap Assembly Precautions
download To prevent damage to the oil ?lter cap assembly, this procedure must be closely followed during oil ?lter replacement to avoid immediate and future oil ?lter serviceability concerns. The...
View Article2003 Buick Century Engine Oil and Oil Filter Replacement Removal Procedure
download 1. 2. 3. 4. 5. Raise and support the vehicle. Refer to Vehicle Lifting. Position the oil drain pan under the engine oil drain plug. Remove the engine oil drain plug. Clean and inspect the...
View Article2004 Ford F-150 Oil Pan, Oil Pump, Oil Pump Screen and Pickup Tube IN-VEHICLE...
download 1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-00. 2. If oil pump removal is necessary, remove the timing drive components. For...
View Article
More Pages to Explore .....